Wilson Electronics X-1 Spezifikationen PDF herunterladen (Seite 8)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Reasons for Weak Cellular Signals

Anyone who uses a cell phone or cellular data card knows the frustration

of not being able to connect to or maintain a strong cellular signal. When

this occurs, it is generally due to one of two reasons:

1. Location of the Nearest Cell Tower – Cell towers are situated to

provide broad coverage; however, there are many areas in which

signal strength may be reduced by topographic features or by local

government restrictions on the height or placement of the towers

themselves. Rural areas generally have fewer cell towers than urban

regions.

2. Natural and Man-Made Obstructions – Signal strength can also

be negatively affected by trees, hills, weather, buildings, and other

obstructions. You may be relatively close to a cell tower but still

unable to make a call. This often occurs in homes, offices and other

buildings in which stucco, concrete or metal walls may block the

signal.

The Signal Booster works with two antennas. The Inside Antenna

communicates with your cellular device and the Outside Antenna

communicates with the cell tower. The Outside Antenna receives the cell

tower signal and sends it through the cable to the Signal Booster, where it

is amplified and re-transmitted much stronger through the Inside Antenna

into the room. When the Inside Antenna picks up a signal from your

cellular device, the Signal Booster amplifies that signal and transmits it

through the cable to the Outside Antenna and back to the cell tower.

Note: The Signal Booster will only operate if there is an adequate signal

to amplify.

Note: Use the directions included with your choice of antenna, the

instructions here are meant for the Wide Band Antenna option

shown above.

The antenna should be mounted as shown in the illustration above. The

included mounting bracket is adjustable and will accommodate pipe

diameters from 1.25 inches to 2 inches (pipe sold separately #901117).

Cell Tower

Drip hole on bottom

Cell Tower

Wide Band Antenna option shown

Outside Antenna Installation

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Wilson Electronics X-1 Spezifikationen Seite 8