Wilson Electronics X-1 Spezifikationen PDF herunterladen (Seite 5)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

1. Select a location to install the Signal Booster that is away from

excessive heat, direct sunlight, moisture and has proper ventilation.

Do not place the Signal Booster in an air-tight enclosure.

2. Select a location on the roof of the building to install the Outside

Antenna. Use a cell phone in test mode to find the strongest signal from

the cell tower. Visit www.WilsonElectronics.com to find test mode

function for your particular cell phone or refer to page 9.

3. Run the Outside Antenna cable to the Signal Booster and attach it

to the connector labeled “Outside Antenna” on the Signal Booster.

Run the Inside Antenna cable to the Signal Booster and attach it to

the connector labeled “Inside Antenna” on the Signal Booster (refer

to page 9 for more information on running cable). Lightning Surge

Protection is recommended for all in-building installations (refer to

page 8).

4. Select a location for the Inside Antenna, preferably in the center of where

the signal needs to be amplified. A minimum separation distance of 20

vertical feet (within the null zone) or 50 horizontal feet is necessary

for proper operation. If the inside coverage is not sufficient you may

need as much as 75 feet of horizontal separation (refer to installation

diagram on pages 5 & 6).

5. Before powering up the Signal Booster, verify that both the Outside

Antenna and the Inside Antenna are connected and check that all

connections are tight (refer to page 11). Note: Be careful when

plugging the connectors in so as not to bend the center pins on the

connectors.

6. The Signal Booster has been packaged with the gain control knobs

adjusted to the highest gain position. If one or both of the lights are

not green, please refer to pages 12 &13.

Quick Install Overview

Refer to Installation Diagram on pages 5 & 6. Contact Wilson Electronics

Technical Support Team with any questions at 866-294-1660.

Warning: Connecting the Signal Booster directly to a cell phone with

use of an adapter will damage the cell phone and/or the

Signal Booster.

IMPORTANT NOTICE

• It is very important to power your Signal Booster using a surge

protected AC Power Strip with at least a 1000 Joule rating.

• Failure to do this will void your warranty in the event of a power surge

or lightning strike.

1 2 3 4 5 6 7 8 9 10 ... 15 16

Keine Kommentare

Wilson Electronics X-1 Spezifikationen Seite 5