Wilson Electronics MAXX 2 Series Spezifikationen PDF herunterladen (Seite 10)

Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660

or email: [email protected]. Mon.- Fri. Hours: 7 am to 6 pm MST.

Powering up a Wilson Electronics Signal Booster

1. Never point the front of a Directional Outside Antenna toward the Inside

Antenna. Refer to Figures 1 & 2 on page 10.

2. Ensure that both the Outside Antenna cable and the Inside Antenna cable

are connected to the Signal Booster and the connections are tight before

powering up the Signal Booster.

3. Plug the power supply into the Signal Booster input marked “POWER” (carefully,

to avoid damaging the center pin) and then into a Surge Protector Power Strip.

4. If the Signal Booster does not have green lights, please refer to pages 10 & 11.

5. If you are not using a band, reduce the gain all the way down to minimum until

the light turns off. This will reduce the power consumption of the Signal Booster.

6. Using multiple Signal Boosters in one installation could cause interference to the

cell tower (except for the In-Line Signal Booster).

7. Contact Wilson Electronics Technical Support Team with any questions at

866-294-1660 or email [email protected]. Technical Support hours

are Mon.- Fri. 7 am to 6 pm MST.

Installing a Wilson Electronics Signal Booster

Select a location to install the Signal Booster that is away from excessive heat,

direct sunlight, moisture and that has proper ventilation. Do not place the Signal

Booster in an air-tight enclosure. Recommended installation locations for in-

building Signal Boosters are near a power outlet and in a closet or on a shelf.

Note: It is important to have adequate air ventilation. Maintain at least 6

inches of clearance from surrounding objects. Be careful when

plugging the connector in so as not to damage the center pins on

the connectors.

Run the Outside Antenna cable to the Signal Booster and attach it to the

connector labeled “Outside Antenna” on the Signal Booster. Run the Inside

Antenna cable to the Signal Booster and attach it to the connector labeled “Inside

Antenna” on the Signal Booster.

Note:

For distances of 20 feet or more, use Wilson low loss cable.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Keine Kommentare

Wilson Electronics MAXX 2 Series Spezifikationen Seite 10